FOX C1 SEMI-AUTOMATIC:

Control Features:
Programmable key pad controls, LCD display screen, Variabel turn table speed 0-15 RPM, Variable film carriage speed up/down control, Seperate top/bottom wrap selectors 1-9, Seperate film height selector 1-9, flush mounted control panel, Cycle counter, Manual carriage raise/lower control, turntable jog with auto home alignment, large emergency push button power On/Off switch with indicator light, start cycle push button, strandard wrap up/down program, 12 volt DC control system, All circuits protected by fuses, 20 amp power board circuits to carry a 10 amp load.

Technical Information:
Power requirements 115 VAC @ 15 amps 60Hz, complete manual with electrical schematic provided with machine.

Turntable Drive:
Positive home alignment and counter, 0-15 RPM turntable speed, 1/2 HR SCR variable speed drive, Adjustable electronic DC soft start/stop.

Structural Features:
Heavy duty 3/8" turntable plate, Fork lift portable from rear, Formed steel tower, 5/16" thick base plate, three 3/8" thick support rings.

Carriage Lift:
Ultra wear slide supports, Heavy duty ANSI #50 chain carriage lift, 1/2 HP DC SCR variable speed drive, Carriage chain fully guarded.

Film Delivery:
Fox "DYNAMIC" non pre-stretch delivery system, constant film tensioning through the entire roll diameter, Capable of 100% plus stretch, Uses hand or machine film upto a maximum of 10" OD, Triple beam auto height eye capable of recognizing all colours including black.

Options:
Loading ramp, extended heavy duty ramp for powered hand truck, base and height extensions in 1 foot increments.